Kay Sievers
779d2d851e
We probe for all known filesystems to find conflicting signatures. If we find multiple matching signatures and one of the detected filesystem types claims that it can not co-exist with any other filesystem type, we do not return a probing result. We can not afford to mount a volume with the wrong filesystem code and possibly corrupt it. Linux ssytems have the problem of dozens of possible filesystem types, and volumes with left-over signatures from former filesystem types. Invalid signature need to be removed from the volume to make the filesystem detection successful. We do not want to read that many bytes from probed floppies, skip volumes smaller than a usual floppy disk.
udev - userspace device management
For more information see the files in the docs/ directory.
Important Note:
Integrating udev in the system has complex dependencies and differs from distro
to distro. All major distros depend on udev these days and the system may not
work without a properly installed version. The upstream udev project does not
recommend to replace a distro's udev installation with the upstream version.
Requirements:
- Version 2.6.19 of the Linux kernel for reliable operation of this release of
udev. The kernel may have a requirement on udev too, see Documentation/Changes
in the kernel source tree for the actual dependency.
- The kernel must have sysfs, unix domain sockets and networking enabled.
(unix domain sockets (CONFIG_UNIX) as a loadable kernel module may work,
but it does not make any sense - don't complain if anything goes wrong.)
- The proc filesystem must be mounted on /proc/, the sysfs filesystem must
be mounted at /sys/. No other locations are supported by udev.
Operation:
Udev creates and removes device nodes in /dev/, based on events the kernel
sends out on device discovery or removal.
- Very early in the boot process, the /dev/ directory should get a 'tmpfs'
filesystem mounted, which is populated from scratch by udev. Created nodes
or changed permissions will not survive a reboot, which is intentional.
- The content of /lib/udev/devices/ directory which contains the nodes,
symlinks and directories, which are always expected to be in /dev, should
be copied over to the tmpfs mounted /dev, to provide the required nodes
to initialize udev and continue booting.
- The old hotplug helper /sbin/hotplug should be disabled on bootup, before
actions like loading kernel modules are taken, which may cause a lot of
events.
- The udevd daemon must be started on bootup to receive netlink uevents
from the kernel driver core.
- All kernel events are matched against a set of specified rules in
/lib/udev/rules.d/ which make it possible to hook into the event
processing to load required kernel modules and setup devices. For all
devices the kernel exports a major/minor number, udev will create a
device node with the default kernel name, or the one specified by a
matching udev rule.
Please direct any comment/question/concern to the linux-hotplug mailing list at:
linux-hotplug@vger.kernel.org