As a follow-up for db3f45e2d2 let's do the
same for all other cases where we create a FILE* with local scope and
know that no other threads hence can have access to it.
For most cases this shouldn't change much really, but this should speed
dbus introspection and calender time formatting up a bit.
Three binaries would fail to link when ld.bfd was used and link-udev-shared was
false. Add -pthreads (again) to the failing binaries and synchronize the
dependency list between libsystemd-shared .a and .so versions.
Apart from allowing the build to succeed, this shouldn't have much effect becuase
systemd-networkd was already using pthreads.
Fixes#5828.
In normal operation this would trigger an assertion
when a DHCP server is configured every time the link goes up.
This change makes sd_dhcp_server_configure_pool idempotent
and stops the DHCP server when the link loses carrier.
In addition to this stopping the assertion being triggered,
this has the useful side-effect of allowing the link to be taken down
and then brought back up as a way to have it use DNS from an "upstream"
interface that got its DNS configuration via DHCP
after the downstream link was configured.
For containers the link is effectively always up,
but for virtual and physical machines networkd may have started
before the link has gained carrier.
Networkd will configure addresses when carrier is gained,
but should also configure addresses if the link is already up.
Without this patch the addresses are set unconditionally.
Normally this isn't a problem since addresses are either fixed,
set over DHCP, or is never without carrier.
But for machines that gain carrier and are configured to select
an address from the unallocated local address pool
this causes them to pick an address from the pool twice.
This change to skip address configuration when a link is added
before it has a carrier fixes having multiple addresses assigned
if the machine starts networkd before it has gained carrier
and is configured with an address from the pool.
When the link comes up it assigns addresses
by checking whether the address is 0.0.0.0,
and if so pulling a new address range out of the pool.
If the addresses aren't removed from the pool when the link goes down
then the set of addresses allocated will grow
until all the local address ranges are exhausted,
while it gets a different IP address every time.
This patch frees the addresses when link config is dropped
to fix the address leak,
and on systems which can expect all interfaces to be brought up or down
in a deterministic order this conveniently makes use the same address each time.
this patch makes it possible to configure a vlan aware bridge without the
PVID. To configure no PVID set DefaultPVID=none in the [BridgeVLAN] section.
fixes#5716
Currently the local variable `address` is unintialized if the DHCP lease
doesn't provide a router address (when r == -ENODATA). Thus the
subsequent call to route_scope_from_address will result in accessing an
unintialized variable.
As a matter of fact, sd-dhcp-client ignores DHCP leases without an
address so link_dhcp_set_routes probably will never be called without a
valid address.
LLDP should be received on bridge slaves as they're the entities
directly connected to a peer. Receiving LLDP on the bridge device makes
little sense, Linux by default even filters out LLDP going onto the
bridge device.
Flip the current logic, receive LLDP on bridge slaves don't listen for
them on the bridge itself.
DHCP responses could include static routes, but unfortunately not an
option to tell what scope to use. So it's important that the client sets
it properly.
This mimics what the `ip route add` command does when adding a static
route without an explicit scope:
* If the destination IP is on the local host, use scope `host`
* Otherwise if the gateway IP is null (direct route), use scope `link`
* If anything else, use the current default `global`.
Fixes#5979.
Add variables for enabling Router Advertisements, router lifetime as
well as managed and other information flags indicating use of DHCPv6.
Add configuration of default router preferences as defined in RFC 4191.
IPv6PrefixDelegation in the [Network] section has to be set in order
to enable prefix delegation. The rest of the prefix delegation values
are stored in the [IPv6PrefixDelegation] section. The host will act as
a default router if it is given a non-zero lifetime with
RouterLifetimeSec. Managed and OtherInformation booleans set the level
of DHCPv6 support, and the RouterPreference configures the router's
preference between low, medium and high. Words 'normal' and 'default'
are added as synonyms for 'medium' just to make configuration simpler.
This adds a section like the following to .network configuration files:
[Network]
IPv6PrefixDelegation=true
[IPv6PrefixDelegation]
RouterLifetimeSec=2000
Managed=false
OtherInformation=true
RouterPreference=medium
Support zero or more [IPv6Prefix] sections in the network configuration
files. Each section can have one Prefix=<subnet>[/<prefixlength>]
option, with the preferred and valid lifetimes specified by
ValidLifetimeSec and PreferredLifetimeSec measured in seconds, and
with onlink and address autoconfiguration booleans specified by
OnLink and AddressAutoconfiguration variables.
This adds a section like the following to .network configuration files:
[IPv6Prefix]
Prefix=2001:db8:dead:beef::/64
OnLink=true
AddressAutoconfiguration=true
ValidLifetimeSec=1500
PreferredLifetimeSec=1000
This adds a modified version of dhcp6_option_parse_domainname() that is
able to parse compressed domain names, borrowing the idea from
dns_packet_read_name(). It also adds pieces in networkd-link and
networkd-manager to properly save/load the added option field.
Resolves#2710.
We know how the field we are parsing is called, let's put this information in
the error message:
"Route Source= prefix is invalid, ignoring assignment: ..."
"Route Destination= prefix is invalid, ignoring assignment: ..."
Using conf.set() with a boolean argument does the right thing:
either #ifdef or #undef. This means that conf.set can be used unconditionally.
Previously I used '1' as the placeholder value, and that needs to be changed to
'true' for consistency (under meson 1 cannot be used in boolean context). All
checks need to be adjusted.
netdev to bond.
There are situations where a link can be in an "UP" state when
systemd-networkd attempts to add the link to a bond device.
This is a problem because the bonding driver will refuse to
enslave a link if it is in the "UP" state.
This check ensures systemd-networkd sets the link to "DOWN"
before attempting to add the link to the bond.
Fixes#5838.
```
[107/1793] Compiling c object 'src/basic/basic@sta/log.c.o'
In file included from ../src/basic/log.c:44:0:
../src/basic/missing.h:762:6: warning: "HAVE_DECL_IFLA_GENEVE_LABEL" is not defined, evaluates to 0 [-Wundef]
^~~~~~~~~~~~~~~~~~~~~~~~~~~
[108/1793] Compiling c object 'src/basic/basic@sta/path-util.c.o'
In file included from ../src/basic/path-util.c:40:0:
../src/basic/missing.h:762:6: warning: "HAVE_DECL_IFLA_GENEVE_LABEL" is not defined, evaluates to 0 [-Wundef]
^~~~~~~~~~~~~~~~~~~~~~~~~~~
```
Lennart Poettering
Zbigniew Jędrzejewski-Szmek
Susant Sahani
Patrik Flykt
Richard Maw
Susant Sahani
Tobias Jungel
Daniel Wang
sjoerd-ccu
Hristo Venev
Michael Biebl
Dimitri John Ledkov
Roelf Wichertjes
Thomas Hindoe Paaboel Andersen
Michael Biebl
Evgeny Vereshchagin